Homemade glass blowing torch

We have all the supplies you need to get started at Glass Crafters. Lu Libby 137views. I have been doing glass torch work since 11. Masahiro Sasaki Guest Artist Demonstration - Duration: 1:45:53.

How to make a powerful propane burner.

Corning Museum of Glass 226views. Improving a small gas torch for jewellery. In this video we are going to set up a two-inlet flame working torch for glass blowing. Simple conversion from a gas cooker to a blow torch.

Things you will need to make your torch 1. Small plastic hose that the cutting tip will fit tight into making airtight seal. Most flameworking requires an oxy-fuel torch.

To have the best usability, it should be a surface mix too, but a premix torch is fine for borosilicate. Fill a glass container with two cups of water and a teaspoon of salt. Insert the carbon rods, with the wires hanging out and the volt battery resting outside the container. Bubbles will start to form in the water.

This video is unavailable. A new low-pressure, stainless steel lampworking torch designe the Bravo is a dual-purpose torch , working easily with both soft and borosilicate glass. See more ideas about Glass blowing , Glass , Oxygen concentrator.

When you have added enough glass , pull away the glass rod (remember to keep the mandrel rotating in the flame). You will get a thin string of glass , just allow the flame to melt through it. Place your glass rod onto the rod rest, out of the way. You may want to switch your mandrel into your dominant hand at this point.

Ignite the flame on your propane blow torch. Position the blue portion of the flame on the glass. Move the blue part of the flame across the glass in even strokes to allow for even heat distribution.

GLASS TORCH TECHNOLOGIES (GTT) The triple mix technology developed by GTT is the advanced use of multiple oxygen ports to control, manipulate, and enhance flame characteristics.

The triple mix torch design surrounds each fuel jet with oxygen and has an independently controllable oxygen injector that shoots oxygen in the middle of the fuel stream. Make Offer - Vintage Glass Blowing Torch Burner AIR GAS OXY. Blowing glass into an ornament is easy with a Bernzomatic torch , glaskolben glass tubes and the right tools.

Glaskolben glass tubes come with blow pipes already attache making them an excellent option for glasswork beginners. Warm the 6-millimeter piece of glass in the torch flame while warming the tip of the base glass piece. Insert the 6-millimeter glass piece into the base glass piece center on the rounded part and press it through.

Blow into the opposite end of your glass tube to begin creating the bowl. Make sure you heat your bowl evenly so that when it blows out, it is uniform. Keep blowing your bowl out until you are satisfied with the size.

Remember, the larger the bowl, the thinner the wall may be. Humans have blown glass pipes since around BC. Yes, years before christ. At the time, the Romans would form their glass pipes using the blowpipe technique.

In other words, blowing glass into a bubble with the help of a blowpipe. To this day, many talented glass artists continue to use that very method. Stacks Torch The smaller of the two torches that can be added to the Stacks system.

Alpha in size and performance. Homemade Torch , Kiln ,Controller and. BBQ tongs turned into square mashers. I enjoy building equipment almost as much as I like to melt glass. Propane Blow - Torch for Glass Blowing ? I light the end with a flint or a lighter.

If I purchased the right glass rods, would I be able to use that as a glass - blowing torch to.